An unassembled Fountain Pump kit

Notice the directions. 

This will assist the delivery person (& the caterer when the beverage runs out & is refilled)

Screw the white female barb onto the pump

Screw the black male barb into the pump.

Slide the 6" tubing over the white barb

Secure with a cable tie

Slide valve into 6" tubing

Secure with a cable tie

Slide 1 of the long tubes onto the other end of the valve

Secure with a cable tie

(This valve controls the  liquid pumping

 out the end of this tube)

Heat up threaded nipple

Burn into the center of the bowl with the hot  nipple

 On the inside of the bowl, place rubber o ring over the threaded nipple.

Place a washer over the threaded nipple

on the outside of the bowl

Tighten 2 nuts (1 on the inside & 1 on the outside)

Slide the second long tube onto the threaded nipple

Secure with a cable tie

Slide the other end onto the Black barb

You have created a loop

(except where the liquid is flying through the air)

This step by step shows how to put the parts together

The photo to the right shows 1 way to incorporate it into an ice sculpture

The valve controls the distance the water  shoots out

Fountains make champagne flat

If you would like to purchase longer tubing click here