Start with one of our new spiral tubes
Slide a funnel into the tube
Slide 2 seals over the post on the long Spiral Tubing Bracket & slide the funnel end of the tube over the blue seals
Now slide one seal over the short Spiral Tubing Bracket & push the end of the tube over the blue seal
Only push it on about a 1/2″ !!!
Now you are ready to put the whole assembly in the block maker
Only push it on about a 1/2″ !!!
Now you are ready to put the whole assembly in the block maker
Place the clips in the block maker
(Notice we are using 2 pumps on day 1)
Cut a stick to fit snugly between the plates
This will hold the plates firmly against the can until they freeze in. (remove after day 1)
Harvest the block & remove the brackets
Click Here to see how we carve this into an ice luge