Lumber Mill attached to a Stihl E220 with a 28" Bar

Build a box 18" x 12" x 4.25"

2"x4"s  & a 3/4" plywood top

Be careful there you drive the screws to avoid

hitting them with your chain.  (I've had this one for 14 years)

Dolly your block onto the box.

Be sure the flat side overhangs the box by 1/2"

Set your Lumber mill for the desired width

Place the guide against the flat surface of the ice

Let the tool do the work, if you push it you will trip a circuit breaker in the chainsaw.  (Green button near top)

By elevating the block you can cut the full 40"

The tool is a bit heavy & cumbersome

You get lots of snow for logos or for

throwing at unsuspecting people in the studio

Click here to get details about the Lumber mill.

See a Video of the lumber mill in action