Start with one of our new spiral tubes

Slide a funnel into the tube

Slide a blue seal over the post on the long  Spiral Tubing Bracket  

& slide the funnel end of the tube over the blue seal

Now slide a blue seal over the short  Spiral Tubing Bracket  & push the end of the tube over the blue seal

Only push it on about a 1/2" !!!

Now you are ready to put the whole assembly in the block maker

Place the clips in the block maker

(Notice we are using 2 pumps on day 1)

Hook the bungee to each bracket (this holds the clip against the can)

***Tip***  Just barely hook the bungee from the bottom (this uses leverage to hold the clip against the can)

After day 2 you can remove the bungee

Harvest the block & remove the brackets

Click here to get pricing for the Spiral Tube Brackets

Click here to see how we carve this into an ice luge