1/4″ End Mill XL 1/2″ Shank
$54.98
Recommended RPM- 24,000
5″ overall length1/2″ shank 3.5″ length of cut 1/4″ tip
This bit fits in both the above 1/2″ end mill holder & a CNC collet.
Related products
-
1/2″ End Mill 1/2″ Shank 6″ OAL
For use in an ice lathe
Recommended RPM- 14,000
Recommended feed rate for Spindle- 3″/Second (180″/minute)
Recommended feed rate for Router- 2″/Second (120″/minute)$52.98 -
Large Sphere Table Jig
$349.98Drill press requirements-
11″ distance between chuck and mounting plate
1.5″ of chuck travel
1700 RPM works very well
Recommended if not using CNC to prep blanks
(prep ice blanks to 6″ x 20″)
-
1/2″ Sleeve
$15.98Convert a 3/8″ shank bit to 1/2″ shank
Put superglue on the shank of the bit then slide sleeve over shank. Allow to fully set before use
One sleeve converts one bit
