Bits
Showing 37–48 of 120 results
-
Ice Sphere bit 1/2″ Inch Shank
Create Perfect Ice Sphere using a Drill Press or CNC.
1/2″ Shank
-
Square Sphere Table Jig
Compact Ice Sphere jig allowing you to make up to 4 sphere from a blank
-
Large Sphere Table Jig
Adjustable table for Ice Sphere making allowing you to make up to 12 spheres from a blank at a time
-
1/2″ End Mill Bit 1/2″ Shank 6″ Inch OAL 2 flute
For use in an ice lathe
Recommended RPM- 14,000
Recommended feed rate for Spindle- 3″/Second (180″/minute)
Recommended feed rate for Router- 2″/Second (120″/minute) -
1/2″ End Mill Bit 1/2″ Shank 6″ Inch OAL
1/2″ Shank x 1/2″ Width x 6″ Over All Length 3 Flute Endmill with 4″ of cut
Recommended RPM- 14,000
Recommended feed rate for Spindle- 3″/Second (180″/minute)
Recommended feed rate for Router- 2″/Second (120″/minute) -
1/2″ End Mill Bit 1/2″ Shank 6″ Inch OAL Ball Nose
For use in an ice lathe
Recommended RPM- 14,000
Recommended feed rate for Spindle- 3″/Second (180″/minute)
Recommended feed rate for Router- 2″/Second (120″/minute)Out of stock
-
1/2″ End Mill Bit 1/2″ Shank 8″ Inch OAL
3 Flutes, 8″oal, 5″ of cut
Recommended RPM- 14,000
Recommended feed rate for Spindle- 3″/Second (180″/minute)Out of stock
-
1/2″ End Mill Bit 1/2″ Shank 7″ Inch OAL
3 Flutes, 7″oal, 5″ of cut
Recommended RPM- 14,000
Recommended feed rate for Spindle- 3″/Second (180″/minute)
Recommended feed rate for Router- 2″/Second (120″/minute) -
1/4″ End Mill Bit XL 1/2″ Inch Shank
Recommended RPM- 24,000
5″ overall length1/2″ shank 3.5″ length of cut 1/4″ tip
This bit fits in both the above 1/2″ end mill holder & a CNC collet.Out of stock
-
Flame Bit with 1/8″ Inch shank
1.5″ overall length, 1/8″ shank
-
1/8″ End Mill Bit with 1/8″ Inch Shank
3″ Overall Length, 1″ of Cut, 1/8″ shank
-
Silver Cyclone Threaded
7.5″ of cut (on a shaft)
Replacement for Zip bit spiral, because it plunges better.
Showing 37–48 of 120 results