Corner of the Block

For this face I chose to start with the corner of the block facing me

Using a Face bit on a Die grinder– Draw on where the hair meets the forehead, & the chin.

Next draw in a wide square nose & connect the lines to draw on the sides of the face

Draw on the hair, for this example I chose kind of crazy hair

Using a chainsaw- Cut out around the hair & a triangle from under the chin

Back to the Face bit– Remove the material around the nose & under the brow. (leave the nose protruding)

Push the forehead back, leaving only the brow & nose sticking out.

Use the side of the bit to taper the cheeks in.

Use the side of the bit to make the head narrower where the eyes are. (Just a little dimple right next to the eye)

Use the face bit to rough in the eye. Start the eye by creating a 1/2 cylinder

Do both eyes, focus on making them the same level & size

Carve back the area next to the mouth

Close up of previous step

Using the top of the face bit, shape the eye. you can even make eyelids with the tip

Carve the mouth, & tuck the lower lip under the upper lip in the cormers

Alternate using the Face bit & a Chisel to shape the hair. The more layers the better

Using a Pistol grip sander, Sand the brow cheeks & chin

Using A Rotary Knife, Detail the hair. Detail each level seperatly

Sand the face with a piece of Green sand paper