< All Topics
Print

Installing a Large Shaft

Video- that shows a complete installation of the large shaft.

Remove the collette nut
Remove the 4 phillips head screws that hold the front assembly on
Remove the front assembly
Unscrew the Phillips head screw inside the black cylinder
Unscrew the Black nut on the front of the die grinder. Note- This is a reverse thread! Hold the neck with a vice. You will get scratches from the vice on the neck. Now mail us the front assembly
Now the next step is a bit tricky. If you don’t have an Arbor press send the front assembly to us & we can do this step for you. Press out the stock shaft. & press the new shaft back in. We will send the neck back after this step.
Place the black cylinder over shaft
Tighten the small Phillips head screw inside the black cylinder
Reattach the front assembly using the 4 screws
tighten the Black nut on the front of the die grinder. Note- This is a reverse thread! You are done