-
Carving Knowledge
-
Tool Knowledge
-
Misc. Knowledge
Spiral Luge

Start with a block of ice that has a tube frozen inside
Attach a template


Using a chainsaw, trace on the template
(cut upwards when tracing with a chainsaw)
Because we carve at room temperature, we can remove the template


Cut out the silhouette or “Cookie Cutter’
Make sure your cuts are very straight while cutting out the silhouette


Cut in the 4 reference lines about 2″
Make 4 angle cuts to the reference lines


Using a 5″ Super disc, Sand all of the surfaces
Using a Pistol Grip Sander, Sand all of the surfaces


Using a 1/2″ Drill & a Hole Drill start drilling the hole
Change the angle once the hole is started


Using a die grinder & a 1/4″ end mill, cut a drain hole from the back
Using the tip of the saw cut in the detail lines


Clean your sculpture
Pour a shot of Alcohol through the Tube
(this ensures that no water will freeze in tube)


Finished Spiral luge
Click here to see how we freeze in the spiral luge
(After a few tries, this design should take about 10 – 15 minutes to carve)