-
Carving Knowledge
-
Tool Knowledge
-
Misc. Knowledge
< All Topics
Print
Spiral Tubes

Start with one of our new spiral tubes
Slide a funnel into the tube


Make sure the cover is over the threads of the top spiral lifter plate
Slide 2 seals over the post on the long Spiral Tubing Bracket & slide the funnel end of the tube over the blue seals


Make sure the cover is over the bottom spiral lifter plate threads

Now you are ready to put the whole assembly in the block maker

Place the clips in the block maker
(Notice we are using 2 pumps on day 1)
Cut a stick to fit snugly between the plates
This will hold the plates firmly against the can until they freeze in. (remove after day 1)


Harvest the block & remove the brackets
Click Here to see how we carve this into an ice luge
