Start with a cylinder
(this one is on a board with a used piece of sandpaper stapled to it)
The sand paper helps keep the ice from spinning
Using a Vee bit make a shallow hole in the middle
Using a Hole Drill, Drill down about 6 inches
Using your hand remove most of the snow
Using a 1/4″ end mill, make a drainage hole
Here a bottle holder is frozen to the top of a logo
![](https://i0.wp.com/www.icesculptingtools.com/wp-content/uploads/2017/03/wsi-imageoptim-ice-bottle-holder-5.jpg?fit=261%2C208&ssl=1)