Mark a line where you will cut. In this case we cut off 20″
Install the provided Saws-all blade in your Saws-all.
Remove- Cotter pin, Pulley wheel & Pin
Lay down cart & cut both uprights with Saws-all
Stand Cart up & put on new bracket (may require rubber mallet)
Fasten with provided fasteners
Reinstall- Cotter pin, Pulley wheel, Pin & Cable
Voila!
If you cut it to 20″ you will get 49lb cart with a new max lift height of 37.5″
![Alum Chop Kit How to 7](https://i0.wp.com/www.icesculptingtools.com/wp-content/uploads/2018/11/Alum-Chop-Kit-How-to-7.jpg?fit=276%2C400&ssl=1)